I have Mikrotik routerOs v2.9.27 Level 6 install in Intel PC. I try to upgrade to routerOS v4.4 so I put routeros-x86-3.30.npk in the files but after reboot nothing happened and the npk file remain as it is .
How can I upgrade my ststem to v4.4
did u try to copy all packages separately?
I copy the combined package only. I also try the separate packages but the result the same.
I put the package in the main folder using ftp. Then reboot but nothing happen and the packages remain as normal file and it didn’t get absorbed
Note: I have intel PC. Is my RouterOS version is upgradeable
but I used to have routerboard and I can just upload by putting the file in ftp and then reboot
hai fren,
no, as far as i remember starting v2.9.28 or highest version should be with netinstall tool to verify your license key.. 
regards
Hasbullah.com
My main workstation is connected to a home router (LAN: 192.168.2.1 , WAN:192.168.1.10). the router is connected to Mikrotik server( LAN 192.168.1.1).
In Winbox, I don’t neet to connect the workstation directly. I can just access Mikrotik using 192.168.1.1. Does this work with netinstall
Most of the article I found is about installing RouterOS. How can I upgrade using netinstall
here fren: http://wiki.mikrotik.com/wiki/Netinstall
and make sure your board PXE BOOT supported
regards
Hasbullah.com
How to make sure that my dedicated PC server support PXE BOOT
here they are taking about install. Is it the same for upgrade and does it keep the current setting?
you don’t need to use PXE, you can just take that HDD, put it as a secondary one in some windows PC, and use Netinstall to install RoutrOS v4.4 onto that drive.
This will work only if you have a valid, purchased license on the drive.