Just connected UPS to one of our nodes.
Want to monitor many parameters, like line and output voltage, battery charge etc.
SNMP shows just a few values:
[admin@mt] > system ups print oid
Flags: X - disabled, I - invalid
0 model=.1.3.6.1.2.1.33.1.1.2 version=.1.3.6.1.2.1.33.1.1.3
status=.1.3.6.1.2.1.33.1.2.1 remaining=.1.3.6.1.2.1.33.1.2.3
voltage=.1.3.6.1.2.1.33.1.2.5 temperature=.1.3.6.1.2.1.33.1.2.7
Maybe I can get them from telnet/ssh? But there are too few parameters:
[admin@mt] > system ups get 0
alarm-setting load name on-line value-name
comment manufacture-date nominal-battery-voltage port
disabled min-runtime offline-after serial
invalid model offline-time version
There is no line voltage, output voltage, charge, BUT all of them are shown on
[admin@mt] > system ups monitor 0
on-line: no
on-battery: yes
rtc-running: no
runtime-left: 1h12m
battery-charge> : 53%
battery-voltage> : 24.7V
line-voltage> : 0V
output-voltage> : 229.6V
load: 5%
temperature: 54.9C
frequency: 50Hz
replace-battery: no
smart-boost: no
smart-trim: no
overload: no
low-battery: no
How can I read them?