*) hotspot - fixed https login (broken in v5.9);
*) eoip: swap tunnel id bytes to be compatible with previous versions;
*) eoip,gre: fix setting config
What’s new in 5.10 (2011-Dec-09 11:49):
*) snmp - provide extended interface statistics when availabe;
*) dhcpv6 client - use link-scoped multicast address;
*) dhcp client - renew dhcp lease on ethernet link up event;
*) ipv6 gre tunnel added (/interface gre6) supports ip and ipv6 encapsulation;
*) ip gre tunnel supports ipv6 encapsulation;
*) allow setting bigger trafflow cache;
*) improved RB1200 stability when using ether9,ether10;
*) fixed RB1200 stability issues when using crypto hardware acceleration;
I did an upgrade from 4.13 to 5.11, and manually installed the user-manager, reboot, then CPU load is 100% and user-manager not working. I see in the profiler, user-manger taking more than 90% cpu usage. So I’ve disabled it, and now all wireless/hotspot client can’t connect.
I did an upgrade from 4.13 to 5.11, and manually installed the user-manager, reboot, then CPU load is 100% and user-manager not working. I see in the profiler, user-manger taking more than 90% cpu usage. So I’ve disabled it, and now all wireless/hotspot client can’t connect. >
Any suggestions?
Answer depends on package you had before upgrade,
v4.x usermanager-test, there should not be any problems with upgrade from v4.x to v5.x;
v4.x usermanager, in some cases there could be problems, and it is easier to start new configuration, if you want to avoid manual reconfiguration of profiles and users.
Please make new post in User Manager section for questions about User Manager!
Since the user-manager is not installed by default, so I installed it manually using the file “user-manager-4.13-mipsbe.npk” which is extracted from “all_packages-mipsbe-4.13.zip”. So, what should I do? Is there any better solution than resetting the ROS to default and reconfigure all again?
When user-manager from 5.11 installed, it’s hard to do anything, cpu load is 100% and winbox become very slow respond. Tried to clear the user-manager database also doesn’t works, it said timed-out or something.
Did you wait long enough? It takes a while for the database to convert/rebuilt. In the meantime the cpu load will be high. I had trouble upgrading from 5.8 to 5.9. I havn’t tried 5.11 yet. Maybe you shuld try 5.8?
Before upgrading - make sure there are no special characters(“-+%€öäå” etc) in profile names, router names etc. and the upgrade will be smother
If you see both “flash” and “userman” in profile with high % - the chance is its still trying to convert. Maybe using an other RB or x86 with more memory will
do it better…
What about trying 4.17 with userman test-package. Run, rebuild and then update to ROS 5…
I’ve upgraded RB751 from 5.10 to 5.11 and it was strange then - rebooting immediately after connecting any cable (from empty switch too) to any of switched ports 2-5. Counter “Total Sector Writes” was erased. I saved config and supout file, then tried to reset configuration using jumper - it was all right then, after loading configuration as well.
There was something about not proper shutdown in the log file, but I didn’t see any supout file. I have supout before crash - I saved it (using ether1 - only port without problems), then connected cable to other port, router crashed immediately and was not able to boot until cable was removed. I can send the supout if it could help to avoid similar behaviour in the future.
