VLAN and Bridge

RouterOS Beginner Basics
1

Hi everyone, i have this scennario:

RB750Gr3 (inntended to be a load balancer)

  • eth1 to RB3011

RB3011 (inntended to be a pppoe srvr):

  • eth1 to RB750
  • eth10 to OmniTIK

Omnitik

  • eth1 to RB3011
  • eth2 to NanoBeam AP (1)
  • eth3 to NanoBeam AP (2)

RB750

  • eth1 to NanoBeam Station (1)
  • eth5 to ADSL Modem

RB941 (hAP Lite)

  • eth1 to NanoBeam Station (2)
  • eth4 to ADSL Modem

i want to create a VLAN between the 2 RB750 and another one between the RB750Gr3 and the RB941. i’m trying to implement the load balancer now, because before i used to do the load balancing on the RB3011. On that scennareo the VLAN’s works, but now i can’t make them work. i’m thinking that it because the eth1 on the RB3011 isn’t bridged with the eth10 and the VLAN’s need a bridge to work? (i clearly have no idea what i am talking about, just guessing).
so any suggestion will be welcome.

2

I am a little confused, In your post, you state this

RB750Gr3 (inntended to be a load balancer)

  • eth1 to RB3011-eth1

RB3011 (inntended to be a pppoe srvr):

  • eth1 to RB750 I am assuming you mean RB750Gr3-eth1
  • eth10 to OmniTIK

Omnitik

  • eth1 to RB3011 According to the above, eth1 on the RB3011 goes to RB750Gr3-eth1
  • eth2 to NanoBeam AP (1)
  • eth3 to NanoBeam AP (2)

RB750

  • eth1 to NanoBeam Station (1)
  • eth5 to ADSL Modem

RB941 (hAP Lite)

  • eth1 to NanoBeam Station (2)
  • eth4 to ADSL Modem

Beyond this, try bridging the VLANs.