Hi I am new to RouterOS and need a little help. My setup is like this From ISP intenet untagged and IPTV Vlan580 to my RB2011. Tag internet with 1000. I want 1 port with trunk 580/1000 1 port with 580 1 port with 1000 How configure Vlan on this setup. Hope you can help me.

There are two ways to configure VLANS in RouterOS. One way is specific to the device, i.e. the switch chip that it uses - I’m not very familiar with it. Other way is to manually configure bridges and assign vlan interfaces, this is what I have used. Below an example: 2 Vlans are created, both of t…

I also forgot to mention that if your device has a switch chip and you will have large amount of traffic - it would be more efficient to use the switch chip. The sample configuration I gave you, will certainly be less efficient. For small amount of traffic over the vlans, most likely it will not ma…

I think this work but I want to try switch hcip to but I dont understand how to configure it…

Apparently, this is how you could do it… http://wiki.mikrotik.com/wiki/Manual:Switch_Chip_Features#Vlan_Table The configuration does not look hard though. In theory, it should be more efficient as all the switching is done in the Switch chip.

Hello Guys, I’ve have similar problem. I’ve got CRS109-8G-1S-2Hnd and RB260G for couple weeks now and I cannot figure it out, probably because my networks skills to poor for this. How to set up Vlans properly, tried numerous guides and a LOT of options on SwOS but no luck at all. So my story: My …

“My ISP provides me with internet (untagged VLAN1) and IPTV (untagged VLAN6). Update: Got on call with ISP - could be untagged VLAN1 for Internet and IPTV (untagged VLAN6), but dude is not certain.” You cannot have both VLANS as untagged. Untagged means plain Ethernet frames, if there’s no Tag in …

Could you also export your config? Just run export in the CLI. It will generate a text file, which is much more compact and easier to work with. You can remove any sensitive information from the export before posting it off course.

This is my setup as I want it. I dont want to use Bridge becouse there is a lot off trafic on IPTV ( 20 Mbit/s ). I have heard that it gets high CPU when there are a lot of trafic on bridge. [image]

Hi guys - been a bit off country, Config attached.Currently for testing purposes switch is connected to port 7 to which IPTV and internet should be sent. On ether 8 - directly to IPTV box which operates normally.

So you use the embedded switch chip: /interface ethernet set [ find default-name=ether1 ] comment=WAN set [ find default-name=ether2 ] comment=LAN name=ether2-master-LAN set [ find default-name=ether3 ] master-port=ether2-master-LAN set [ find default-name=ether4 ] master-port=ether2-master-LAN set…

VLAN Help needed

RouterOS Beginner Basics

Edvinas March 21, 2015, 10:15pm 14

Well I don’t know how i missed that.. Looks so simple now and I got my config right and working properly. Thanks guys.