VLAN Trunk over two RB250GS?

SwOS
1

Hi there. Ive made the setup above successfully, but couldn’t figure how to connect a second RB250GS on the same way. As you can see above, SwOS port 1 have VLAN enabled with “add if missing” parameter selected. The other ports just have a pertinent VLAN ID and mode “strict” with “always strip”. All that works fine.

Please, help me on the scenario below. What is the SwOS config for port 5 on that first RB250GS and port 1 on that second one?

Ive made a couple tries with no success at all, is that even possible?
Thank you in advance.
Ozelo

2

Yes, this scenario should work without any problems. On 1st switch make sure you have entries in VLAN table with ether1,ether5 for each VLAN-ID and port5 set VLAN header = leave as is. There are no need for adjustments on 2nd switch.

3

Works like a charm! Thank you very much.

Ozelo