VLAN's via bridge working but still confused

By default, WinBox only displays “current”, and if you don’t have an interface plugged into one of the access ports that vlan 3 is on, then it won’t be displayed in the “current untagged”.

I had a similar question here Bridge VLANS hEX S v7.2rc4 /interface bridge vlan print with the solution post #3. But even after that, I couldn’t get it to work, because I didn’t understand how to select columns, which I was expecting to behave more like wireshark. How you must add columns is described in post #7

As far as ether2, it is hard to say without seeing your sanitized exported config. My guess is that it is because of default pvid 1.