VPN and firewall setup

RouterOS Beginner Basics
1

Hi all,

I finally managed to setup a surfsahrk VPN on my CCR with routerOS 6.45.

Actually I have three LNA’s:
bridge1 on eth2-5
bridge2 on eth7
eth6 direct

I made firewall addresses to all three LAN.
VPN can connectoto only one with mode-config and I connected to eth6.
In fact ipleak from eth6 gives the VPN address, IPLEAK from a workstation in bridge1 or bridge2 give my ISP’s address.
all ok.

Now:

  1. when I try to connect to the router port address of bridge1 form chrome, it says not reachabel …if I try to bridge2 it connects … ???
  2. is it possible to assign two or more LANs to the VPN? IP–>firewall–>address-sist allows for only one set of ip’s and IP–>IPsec–mode-config allowas for only one of these addreses ..

thanks
John