VPN traffic in bridge-mode

RouterOS General
1

Hi,
Using the Quick Set I configure a PL6411-2nD into PTP CPE CPE. As I understand it this configure the device into bridge-mode, which is what I wanted,
i then setup a VPN with my provider and I do see the tunnel attributing an IP to my bridge. I also remove the ether1 interface from the bridge

What I would like to know if there is a way to actually setup my PL6411-2nD in such a way that all traffic from my ether1 port go through this VPN without configuring the PL6411-2nD as a router and NAT

Rock.

2

This is only be possible if the VPN itself is an L2 one. If the VPN assigns just one IP address per user account, you need the router and NAT functionality to connect more devices using the same account, on the PL6411-2nD or on another device; in the latter case, the VPN client would also have to run on that other device and the PL6411-2nD would have to act as a mere bridge.