Walkthrough on Trango Atlas AP > SU Data?

RouterOS The Dude
1

Can someone walk me through the steps to take to get this properly?

Basically this is how it works. Our Trango AP holds all the information for our Subsriber Units. (Rssi, rf traffic, eth traffic etc). I can SNMP walk the AP no problem and it pulls exactly the data I need and even converts the numbers into usable numbers for me! Very nice! However this is my problem.

Example AP is 10.1.1.200. SU is 10.1.5.11

Want to set up a device as 10.1.5.11 and graph it’s ping times. But I also want to graph it’s RSSI, which has to be queried from 10.1.1.200. (Which is a different IP)

I’ve seen how you can snmp walk and add a data source but it has never worked for me properly.

Can someone walk me through exactly how I can do this without it being a completely tedious job. I will have to do this for a good 400-500 users if I like this software. So far it is very VERY good especially for being free.

Thanks for any help anyone can offer.

2

The only way i know of is the painfull way… a custom function and probe for each su you want to monitor.

If im wrong someone please tell me :laughing:

3

Thanks for the tip. That is pretty painful and if you make any changes it’ll be a pain in the butt to add people and subtract and change people all the time..

Sigh..