WAN interface traffic is greater than LAN interface

[jwelebd]

hi
i have a mikrotik router 3.22 version installed on a celeron pc with 2GB RAM. I serve 2.5mbit/s for 180 clients. But there is a problem that WAN interface RX is greater than LAN interface TX and it is too much different sometime. At that time internet speed goes down. In /tool torch when i see the tarffic with source-ip only then it shows some ip’s RX rate is too much high like 384kbit/s or 512kbit/s. but i din not assign ip to my client more than 256kbit/s. For this problem internet speed become slow also. How can I prevent it?

[jwcn]

Are you possibly using proxy? Sounds like you have some type of security hole on the WAN side.

[jwelebd]

yes i am using transparent proxy. how can i prevent it?

[jwcn]

Look at the wiki, basically you need to drop any incoming packets on the WAN interface on the port your proxy is using.

[samir494]

you can do like this

in bridge there is filter = use it to resolve your issue by making changes in the rule one by one to sure it works properly

@jwelebd

hi
i have a mikrotik router 3.22 version installed on a celeron pc with 2GB RAM. I serve 2.5mbit/s for 180 clients. But there is a problem that WAN interface RX is greater than LAN interface TX and it is too much different sometime. At that time internet speed goes down. In /tool torch when i see the tarffic with source-ip only then it shows some ip’s RX rate is too much high like 384kbit/s or 512kbit/s. but i din not assign ip to my client more than 256kbit/s. For this problem internet speed become slow also. How can I prevent it?