I have a single SBE WanPMC DS3 card installed in one of my routers. Our DS3 provider is seeing CRC errors on their router. We’ve gone through a number of troubleshooting steps including swapping out cabling, etc. It would be very, very helpful to me if I were able to see CRC errors on my side as well. Does anyone know if there is a way to get more information about what’s going on with my interface?
BTW - Mikrotik: the lack of stats on this and on my ethernet interfaces makes things tough. It sure would be nice to have more there 
Also, just in case anyone else wants to give any advice, here’s the config for that interface:
/ interface wanpmc
set wanpmc1 name=“wanpmc1” mtu=1500 line-protocol=cisco-hdlc clock-rate=0 clock-source=external
receive-equalize=no crc32=no front-panel=yes framing-mode=hdlc frame-type=t3-cbit
fractional-mode=none fractional-bwf=0 fractional-bwl=255 long-cable=no scrambler=off
frame-relay-lmi-type=ansi frame-relay-dce=no chdlc-keepalive=10s disabled=no