WAP 60G AP: No DHCP and -same mac-address as wlan60-station-1 warning

RBwAPG-60ad-A Recently updated to 7.23.1

I notice I get a new red error in the wireless tab

-same mac-address as wlan60-station-1

Also last week I noticed my building on the other side of the link appeared to be offline.

Using romon I could reach the far radio and far switch. Both showed no IP address. I tried rebooting the devices attached to to them. They failed to get new IP addresses from the router. I then rebooted the far switch, no change. Rebooted the far radio, no change.

Rebooted the NEAR radio the WAP 60G AP. As soon as it came back up all the devices on the far side of the link made DHCP-Requests and came back online.

So ROMON worked to even connect to the devices on the far side of the link. However no DHCP-Traffic would pass.

First time I have seen this unit do this and the red error about the same mac.

Should this be in hardware?

Since the 7.23.1 update I have the same error on master end of a pair of CubeG-5ac60ay. In the interface list I see a red warning against both wlan60-station-1 & wlan60-1 saying they are in conflict, but I have traffic flowing over the bonded interfaces so havent't probed too deep. I made no config changes so seems purely a consequence of the update.

Same problem here after installing 7.23.1. I got around the problem by switching to the Long Term Channel and installing 7.21.4. Really shouldn't have to do that - Whatup Mikrotik??

Same here. SUP-217535. Cheers