wAP with missing N rate

Hardware MikroTik hardware general
1

Hello,

My old Buffalo routed died after 14 years. I purchased an hEX and pulled out of the drawer an wAP. Things are up and running but I am missing N rate (and also bandwidth) from wAP.
From this image you can see that there are only A, B and G rates:

My basic setup:

Routerboard and FW info:

From the official specifications https://mikrotik.com/product/RBwAP2nD#fndtn-specifications n should be supported.

Speed test is of about 15 Mbps down and 9.7 Mbps up (I have a 250/10 Mbps line)

What am I missing here?

Regards.

2

N rates table is not under “Data Rates,” it is under “HT MCS.”

3

Besides, please don’t use extension channels on the 2G radio. And…do you really need 802.11b support?

4

Hello,

thank you guys for the advice. Of course after reading the manual I also understood it. Sorry for littering the forum with stupid questions.

Regards.