WDS default bridge

RouterOS Wireless Networking
1

please i need help

i have a AP-bridge setup and wds station clients when i set default WDS bridge in AP the client just keep connect and disconnect

and i need to bridge the wds to allow access to the ether1 for clients

any solution please ,

2

http://wiki.mikrotik.com/wiki/Transparently_Bridge_two_Networks

see the link…
i am newbie also refer to that then can linked up..

3

im using the same way but the client keep connect and disconnect if i put default wds in wlan
and connecting if i disable default wds but not bridging between interfaces

4

Once you done the setting follow the wiki…
The next is, do some setting in ..

AP (Bridge Mode):
under wlan interface..
under Nstreme tab…

  1. Enable the Nstreme - this can help to increase the throughput at least 30%
  2. Enable Polling - This polling is useful cause it’s use to keep communicate with the client without wasting any resource and also can help to improve reliability.
  3. Disable the CSMA if you running on point to point (Bridge setting at AP side, and wds-station at client side)

Client (Wds-station Mode):

  1. Enable the Nstreme - this can help to increase the throughput at least 30%

That’s what i done and tested ok.
Hope it can help you, or you also can email me at .. bt.ang@mykris.net