Hardware : CRS125-24G-15-RM
WebFig : v6.12
routeros : 6.12
I am logged in as an ‘admin’ on the switch via the WebFig interface. My goal is to setup 4 bridges and assign groups of ethernet ports from the CRS125-24G-15-RM to each of the bridges.
Following the [http://wiki.mikrotik.com/wiki/Manual:Initial_Configuration], in the section “Check Ethernet Interface State”, the manual makes clear that when I inspect a specific ethernet interface property manual, there is supposed to be a “Master Port” pull down menu – between the ARP and Bandwidth entries.
I do not see a “Master Port” pull down menu when I click on specific interfaces of my CRS125-24G-15-RM. Thus, I have no way to over-ride the default settings where ports en2-en24 are slaved to en1.
What option or setting am I overlooking to enable the ability to assign specific ethernet interfaces to a specific “Master Port”?