What mode is my hEX in after a reset?

RouterOS Beginner Basics
1

Hi folks,

So I have a hEX (RB750Gr3) that I have reset to default settings.
How do I figure out what mode it starts in?

I’ve found two diagrams:
https://i.mt.lv/cdn/product_files/RB750Gr3-dsw_161117.png
https://i.mt.lv/cdn/product_files/RB750Gr3-esw3_190642.png

Which one is it?
I plan to use it for my home internet connection, IPv4 only.
So I need one “WAN” port, and the rest can be set to “LAN”, all bridged together. NAT needs to be enabled.
Who can help me out? what do I need to look for?

2

Default is quite probably https://i.mt.lv/cdn/product_files/RB750Gr3-esw3_190642.png

Port ether1 is not part of bridge and thus not switched, other ether ports are part of bridge and thus switched.

Unless you configure some bridge feature which prevents bridge from being HW offloaded (e.g. VLAN filtering in ROS versions lower than 7.1) in which case it’s the other schematic (for the disabled switching setup).

3

Default is like you indicate.

4

https://help.mikrotik.com/docs/display/ROS/Default+configurations