Winbox is empty when connecting to Omnitik

RouterOS General
1

Hello,

I have a remote location where an Omnitik is installed as an Access Point. That Omnitik starts a PPTP connection to my router (RB2011) locally at my permanent location.

From this location I can SSH to the Omnitik, and everything is fine using the command prompt.

When I start Winbox on the same location, I get connected, but I see a complete empty configuration. No Ethernet interfaces, no IP’s, no routes… Just empty!


After 30 seconds or so, Winbox disconnects.

What can be the problem?

2

Bad connection. Very slow and dropping packets. Maybe there is MTU problem so bigger packets are lost instead of to be fragmented.

3

Correct, the internet in that country is very very bad. So I am happy that at least this works.

Opening webpages of devices (like RB260GS, main router etc…) does not work.


What setting of MTU can be considered for improvement of the link?

4

Make the test with nonfragmented ping rising the packet size. You will see…

5

Webfig is fine? Webfig should be faster, maybe use that instead.

6

Webfig is not working at all. It times out as any other webconfiguration page of any device (like ADSL modem is not reachable by web etc..).

7

OK, I changed the MTU to 1300 and the MRU to 1300 and it works now.

8

I told you… Glad it helped.