wireless-fp and -cm2 problem rb951ui-2hnd / ros 6.36

RouterOS Beginner Basics
1

Hey there, would appreciate your help.

Just updated rb951ui-2hnd to current stable ros 6.36 and got this lame problem:

  • wireless-cm2 won’t enable (presence of -fp?)
  • -fp won’t enable and uninstall (dependencies?)

Tried to install -cm2 and -rep (chaotic night decision okay) and here what it looks like now:

[size=100]advanced-tools	6.36	Jul/20/2016 14:09:10 [/size]
dhcp	6.36	Jul/20/2016 14:09:10		
hotspot	6.36	Jul/20/2016 14:09:10		
ipv6	6.36	Jul/20/2016 14:09:10		
mpls	6.36	Jul/20/2016 14:09:10		
ppp	6.36	Jul/20/2016 14:09:10		
routeros-mipsbe	6.36	Jul/20/2016 14:09:10		
routing	6.36	Jul/20/2016 14:09:10		
security	6.36	Jul/20/2016 14:09:10		
system	6.36	Jul/20/2016 14:09:10		
X	wireless-cm2	6.36	Jul/20/2016 14:09:10		
X	wireless-cm2	6.36	Jul/20/2016 14:09:10		
X	wireless-fp	6.33.5	Dec/28/2015 09:13:47		
X	wireless-rep	6.36	Jul/20/2016 14:09:10

Packages DO mark for installation or enable but after restart return to this state.


Got a fine tuned config, so I don’t consider a full reset.

2

Try deleting or disabling the wireless-fp package. It is not supported in v6.36.

3

Yep, marked for uninstall, but after reboot it remains there disabled.

4

That’s normal if it is part of the “Main Package”. You can only disable it.

Try disabling “wireless-cm2” and enable “wireless-rep”.

If you are worried about not losing your configuration you should make a backup file then you can restore you current configuration after a reset. Just go to “Files” and click on “Backup”, name the backup and check mark “Don’t Encrypt” and click the Backup button.

5

Marking for uninstall and to enable do not work. After reboot status stays the same (1st post).

6

You can’t uninstall wireless-cm2. You can only try to disable it.

Try downgrading to 6.34.6. Wireless-rep wasn’t in use then so that should be eliminated and you should have only wireless-cm2 and wireless-fp packages. If they are both disabled try to enable wireless-cm2 . If wireless-fp is enabled then disable it and enable wireless-cm2. If you get cm2 enabled then upgrade to v6.36. You should end up with only the cm2 wireless package.