Hi
this is my first installation and when I connect dishes, on both are only 1 led light - power.
i try to move dishes and no other LED become active.
I did not use the aim tool!
the length is about 200m and good visibility.
when I try to connect via winbox, I did not see any other device.
tried this from both sides.
Admin dish was connected to router and also disconected.
on PC I set static IP 192.168.88.1
link to photo of instalation
https://ibb.co/DM4fmF2
Check if they link in close proximity <10m. If not, best would be to contact MikroTik support with supout.rif files provided
On the wireless setting Tab under Mode is one set to bridge(AP) and the client is set to station bridge?
Do a scan on the station bridge and you should see the Bridge(AP)
Normally the Power and WiFi Led should be on after the alignment…
First, check the configuration on both devices, and also make sure on the AP side the status is in Running state…
Check the logs on both devices too…
Did you made any changes to their configuration ?