dear mikrotik,
we have several situations where it's necessary to elect a master in redundant configurations via vrrp. this master/backup scenario is than used as an example to enable/disable bridges for layer 2 redundancy, where stp is not possible.
the problem with the current solution is, that whatever change you make in the 'interface vrrp script' - it triggers the interface to be reset to backup state, when it was master before till it elects itself again to master after a few seconds..
so in our example, all pppoe sessions trough the script referenced bridges get kicked, only because adding an additional bridge to the script.
please prevent this unnecessary transition behavior on change of uncritical vrrp parameters.
thanks and best regards,
wolfgang