Models Tested: RB750UP-r2 and RB960PGS (Firmware also updated)
Both units were reset to defaults with no config. These are the steps i took to set up a simple bridge and port isolation:
1. Create bridge with protocol mode to none
2. add all ethernet ports to bridge making sure hw offload is enabled for each. (verified with 'H' flag next to each port)
note: ether1 is the uplink port and ether2/3 are PC's
3. Switch>Port Isolation>ether2>Forwarding Overide ticked>Forward to ether1
4. Switch>Port Isolation>ether3>Forwarding Overide ticked>Forward to ether1
No internet access or communication between PC's. Router is accessible. If i disable Hardware offload for ether1 in the bridge ports, things work as expected. If i re enable Hardware offload on ether1 but disable it on ether2, the PC on ether2 gets internet access but the PC on ether3 does not.
Am i doing something wrong or is this RC still very buggy?
regards.