I really am confused by routing in V7.. in v6 going to /ip route. was easy I could add static routes and either select an IP or an interface as a gateway and they would work.. what I find with V7. is /ip route is confusing with percent symbols and such..
I have 2 L2TP client VPN s that auto establish when ROS is booted and LTE comes on line.. I have VLANs for IP phones and for the laptop wifi user..
this means I apply various static routes some go to the VPN some go out to the internet via firewall masqueruede.. what im finding is roputing often "stuck" when doing a traceroute at my local router.. when I run V6 this doesnt happen..
I can only believe it has to do with the mew routing module.. is there a way to get rid of routing route table and go back to standard / ip route scenerio in V7?
I dont do any marking, everything is static route using either an IP or interface as gateway depending on where its going..
I tried doing an ipv6 disable in settings via command line to see if that would help. no dice..
when I take my config and drop it back into an ROS v6 unit identical (and then re-enable PPP on my LTE since MBIM wont work or I use an R11 card) then everything eworks as expected..
I know my VPN tunnel,s are workjing as i can access the hosts behind then from the ROSv7 device itself fine.. I can ping the hosts from a laptop just no access.. it seems something in this wierd routin g method is causing me issues.. my /ip route i nthe gUI changes all the time..
ive read the short little blurb in the online doc. but doesnt seem to make much sense.. seems like all the routes should still be added to the main table. but they work when they want..
anyone else have routing issues with v71beta ?