Page 1 of 1

[Beta 3] Wireguard and IPv6 Peer Endpoint

Posted: Sat Jan 16, 2021 5:48 pm
by einichi
The peer config for Wireguard in beta 3 appears to accept IPv6 addresses for the endpoint-address var, but the resulting peer object's endpoint-address content is empty. This occurs in CLI and Web.

IPv6 addresses either need to be prevented from being entered, or parsed properly to the Wireguard tools.

Naturally, I would be very grateful if you could allow Wireguard to connect to peers via IPv6.

Let me know if you need further information.

Re: [Beta 3] Wireguard and IPv6 Peer Endpoint

Posted: Thu Jan 21, 2021 5:49 am
by einichi
I have another WG interface set up for road-warrior purposes and that's working great btw (except it doesn't process allowed-address properly on Webfig, but I think you're aware of that)