Community discussions

MikroTik App
Frequent Visitor
Frequent Visitor
Topic Author
Posts: 77
Joined: Sat Sep 18, 2004 3:43 am

snmp health voltage not updating unless open in winbox

Wed Feb 17, 2021 9:24 pm

I am using snmp to pull the health voltage and create a chart. The value coming from the snmpget is always the same (I know the supply volts are not constant during the day, its a solar/lithium supply), until I open winbox and look at the System Health tab. Then the snmp value suddenly becomes dynamic and correct updating values to the chart. When I close winbox, it goes static again. This is on a wAP R ac with v7.1b3 and v7.1b4. The mib for health volts in my case is .

Who is online

Users browsing this forum: No registered users and 5 guests