10gbit using the sfp+ port with iperf single threaded.
How did you do that test with only one SFP+ port on the RB4011? What was it routing
from and
to? Did you use some sort of
bonding configuration to turn the ten GigE ports into a single 10G connection, and if so, how did you get it to work with a "single threaded" test? If you'd referenced MikroTik's BTest, I'd understand, since then the source or sink could be internal to the router, but iperf?
There's a wishlist item for MikroTik: an iperf package for the current switches and routers. The current "btest" implementations for regular PC platforms fail to communicate with BTest on current ROS releases due to
a change in the authentication protocol.
wireguard I achieved around 900mbps on the 4011.
Yeah, none of the
Wireguard crypto primitives are in the
hardware-accelerated crypto row for the RB4011, so there's another wishlist item: hardware ChaCha20 acceleration.
a lot of folks miss on the 4011. Using the ports in a bridge with vlan tagging greatly impacts performance.
Is it safe to say that only the CRS3xx devices support switch-chip-level inter-VLAN routing? That's how I'm reading
this table.