Wed Sep 01, 2021 6:06 pm
I believe I've found a bug. With hardware routing enabled on netpower 16p on rc2, if you remove an interface that is in the data path hardware routing seems to have some struggle. Disabling and re-enabling hardware routing resolves it. It's reproducible for me. The symptoms are that the routes from before removing a port work but anything added in relation to that port afterwards dont. ie, I separate a port and then set a route over that port, the hardware path doesn't work even though it's shown to exist and be 'H'. other, pre-established hardware routes continue to work. It's as if that port removal did cause the hardware routes to get rebuilt appropriately. clients on one side of the device pass no traffic with the new route. A quick disable/enable hardware routing on the switch and it resolves.