Community discussions

MikroTik App
 
teleport
newbie
Topic Author
Posts: 48
Joined: Mon Sep 07, 2020 11:51 pm

7.1.3 Zerotier issue

Fri Feb 25, 2022 7:59 am

after successful setup of zerotier
the command /zerotier/interface/print shows correct output and connection is fine.
ip/address/print where interface~"zero"
returns nothing. the interface has no zerotier address

Device:RB450GX4
 
jookraw
Member Candidate
Member Candidate
Posts: 143
Joined: Mon Aug 19, 2019 3:06 pm

Re: 7.1.3 Zerotier issue

Fri Feb 25, 2022 12:35 pm

I've noted an issue with ZT interfaces not getting configured from the ZT portal. assigning the address manually does make the interface work, but, this is not how it is suposed to work.

I do see that Mikrotik devices show the ZT client as an older version.
below you can see what I'm talking about, one is a Linux machine, another is a RB5009 running 7.2rc4 :
Screenshot 2022-02-25 113306.png
You do not have the required permissions to view the files attached to this post.
 
jookraw
Member Candidate
Member Candidate
Posts: 143
Joined: Mon Aug 19, 2019 3:06 pm

Re: 7.1.3 Zerotier issue  [SOLVED]

Fri Feb 25, 2022 12:56 pm

Try enabling this:
Screenshot 2022-02-25 115545.png
You do not have the required permissions to view the files attached to this post.
 
User avatar
osc86
Member Candidate
Member Candidate
Posts: 197
Joined: Wed Aug 09, 2017 1:15 pm

Re: 7.1.3 Zerotier issue

Fri Feb 25, 2022 2:45 pm

and if you choose to use a custom subnet in the controller by specifying the start and end ip address, make sure you have a matching route for this subnet in the controller as well. Without it, peers won’t get addresses assigned, even when the managed flag is set.
so if you choose 10.13.37.1 - 10.13.37.254 also add a route 10.13.37.0/24 without a gateway.
 
teleport
newbie
Topic Author
Posts: 48
Joined: Mon Sep 07, 2020 11:51 pm

Re: 7.1.3 Zerotier issue

Fri Feb 25, 2022 7:54 pm

thanks.works now. just wish this was documented well in the help/wiki section for zerotier.
in the past this was working without explicitly assigning this flag when things had to be done via commandline.
Try enabling this:
Screenshot 2022-02-25 115545.png

Who is online

Users browsing this forum: No registered users and 12 guests