im read a lot about how to setup a Hotspot, maybe to much, it confused me.
I have the folowwing configuration.
eth1 - LAN with IP Pool 10.10.0.0/20
eth2 - WAN1 PPOE dialup (moin provider)
eth3 - WAN2 get IP by dns from router (not setup now) (failover provider)
pppoe-out1 linked to eth2
i want, user get displayed the login.html and have to click button, for accept Terms & Conditions.
No login by user. This musst be displayed to the user, also if WAN2 provide internet.
1. for which interface i have to setup the Hotspot
2. i need a bridge?
3. i need a default route for hotsport to setup?
4. searching for some exsample login page with button solution. found same think there in forum, but only piece of a solutions.
any help welcomes.