Page 1 of 1

CRS125 as in-house switch

Posted: Thu Dec 17, 2015 10:08 pm
by cavaughan
Got a CRS125-24G-15-2HnD-IN Could Router Switch.
All I really want to use it as right now is as an, let's say, in-house switch, or just a switch. No routing will needed between networks. Another server in the office works as DHCP, so I just need this CRS125 to really be a switch/hub. So far, I've been able to kind of get it there, but I'm obviously not configuring it correctly.
And because I'm so limiting the possibilities of this device, I think I may be the first person to do this. Can someone get me routed (ha!) toward the right answer to get the device functioning. I'd really appreciate it.

Re: CRS125 as in-house switch

Posted: Thu Dec 17, 2015 11:06 pm
by troffasky
Pretty sure it works out of the box as a switch, at least on ports 2-24. Port 1 may be a WAN port.

Re: CRS125 as in-house switch

Posted: Fri Dec 18, 2015 3:57 am
by skuykend
You can connect with WinBox, do a system/reset configuration and check 'No default configuration'.

After it reset's connect via WinBox again via Mac address and set the master port for Ethernet interfaces 2-24 and sfp to Ether1. (May disconnect temporarily)

If you want a management ip for WinBox, Webfig, etc. you can assign one to the master port Ether1.