Thank you very much. It realy is logical, i just couldn figure out how to have two ports with taged vlan, i didnt tought that you "have to create vlan 10 twice". Thank you very much I will try this as soon as possible.
I have another question is this possible with switch function on RouterOS?
I followed tutorial on this site http://wiki.mikrotik.com/wiki/Manual:Sw ... p_Features
but this is just how to get untaged vlans to ports, i would like to get one taged one untaged vlan to some port.
set ether3 master-port=ether2
set ether4 master-port=ether2
set ether5 master-port=ether2
/interface ethernet switch port
set ether2 vlan-mode=secure vlan-header=always-strip default-vlan-id=200
set ether3 vlan-mode=secure vlan-header=always-strip default-vlan-id=300
set ether4 vlan-mode=secure vlan-header=always-strip default-vlan-id=400
set ether5 vlan-mode=secure vlan-header=add-if-missing
/interface ethernet switch vlan
add ports=ether2,ether5 switch=switch1 vlan-id=200
add ports=ether3,ether5 switch=switch1 vlan-id=300
add ports=ether4,ether5 switch=switch1 vlan-id=400
Thank you very much once more for this help. I was thinkig to complex