I have a issue with CAPsMAN. I will try explain it in simple terms. When I don't use CAPsMAN, so I'm using simple two AP, I can connect to these AP and reach the internet.
But when I create CAPsMAN I can't reach the internet with CAP1. CAP1 is nicely connected to the CAP manager. If I change some AP settings on the manager the config on the CAP1 is nicely mirrored. This is just fine. But I can connect only to CAPsMAN AP to reach internet. If I connect to CAP1 AP the device don't receive any DHCP parameters and obviously I can't reach internet. In addition I can't see registration in the Wireless tables.
But when I disable CAPs mode on the AP the device is working well. In other words, I can use only the CAPsMAN AP to reach internet.
I think that the problem is very simple because I don't have any complex config on the devices. Even though I can't figure out why this is not working.
The CAPsMAN device is wAP and the CAP device is hAP. Both devices are configured in the same manner:
Eth1 and WLAN1 is in Bridge mode (without STP, STP = none)
Can anybody help me with this issue or any suggestions? I am novice with the CAPsMAN but I think this is a very basic scenario.
Thank you very much for any help.