Community discussions

 
learnyee
newbie
Topic Author
Posts: 31
Joined: Fri May 20, 2016 8:55 pm

Getting really confuse - Swith vs Bridge

Fri May 20, 2016 9:59 pm

I came from the environment using routers and firewalls from Cisco, Juniper and Checkpoint. Recently I had bought a unit of RB2011UiAS-2HnD-IN & CRS125-24G-1S-RM for testing purposes.
Read through the wiki and google, and I started to get real confuse with the term "Layer 3 switch", essentially both model above run the same RouterOS, and most examples illustrated the switching by setting a multiple port (in a switch chip) bind to a master port, then multiple VLAN to the individual port then individual IP to the VLAN and finally the route table.

Hope some can help me to answer the following:
1. In cisco, I had been doing IP Route by manually assigned a IP to a port, then define the route accordingly and it would route just fine, is the same applicable for RouterOS?

2. Does this "Layer 3 Switching" in RouterOS has to work with the VLAN?

3. Understand that there are 2 switching chip in RB2011UiAS-2HnD-IN, will this switch chip help in terms of IP Route?

Thanks in advance for helping.

Who is online

Users browsing this forum: No registered users and 14 guests