I have used load balance Configuration whit recursive GW.
Configuration work good.
I have problem whit my POP3 Mail. My mail is on one of my Internet Provider WAN1.
I can send Email's only from him, receive is not a problem ( that is the configuration from Provider ) It can't be changed .
That is the reason that want to make my local PC when try to access mail server of this provider to go through WAN1.
I have try this :
add comment=Mail distance=1 dst-address=126.96.36.199/24 gateway=ether1-gateway
Try whit mark of source (local) IP which use POP3,
add action=mark-connection chain=prerouting new-connection-mark=Mail passthrough=yes src-address=192.168.0.11
add comment=Mail distance=1 dst-address=188.8.131.52/24 gateway=ether1-gateway routing-mark=Mail
Try whit mark of dst adress of POP3,
add action=mark-connection chain=prerouting dst-address=184.108.40.206 new-connection-mark=Mail passthrough=yes
add comment=Mail distance=1 scr-address=192.168.0.104 gateway=ether1-gateway routing-mark=Mail
Mark is working ....
but routing not working always