Hi Folks,
So, I understand that this is not “active” PoE, but rather “passive”
which (should) allow me to power the board itself through PoE.
Purchased the Cable Matters Inline Passive Power Injector over Ethernet
cable set (essentially 2, Y shaped cables, I can diagram if helpful but
pretty straight forward)
https://www.amazon.com/gp/product/B01J6 ... UTF8&psc=1
In looking at the MikroTik wiki PoE-In section, the pin out is correct
https://wiki.mikrotik.com/wiki/Manual:PoE-In
Needless to say, this isn’t working. Have mucked with terminal, going
so far as “/interface ethernet poe settings print” which generates
“bad command name poe” , as I suspect the PoE commands are
for boards with active PoE.
SO, my question is how can I configure this board to power up over PoE?
Thanks for any help