Hi my friends,
I have got a little problem in a very simple network, shown here.
I simply do not see the problem. Most sorry. Your help would be greatly appreciated.
I have got in this scenario two MikroTik devices. For details, would you please have a quick look on the screenshot from the home office pc:
I configured this RB450G with no defaults and afterwards used the “quick setup” to setup a Bridge mode (static), as you can see here:
My hAP ac (which I like a lot) is also a default configuration and the setup follows the ‘Home AP dual scheme’, as you can see here.
My German DSL router btw. actually only connects to the internet, no problem here whatsoever. Its internal IP is 192.168.1.2.
The MikroTik hAP AC in my home office works great and I have had no problem whatsoever.
However, my problem is downstairs, because I can only plug two network cables into my RB450G. When i insert the 3rd cable I get a reboot loop.
EDIT: Same with only two cables, ether1 and ether2, plugged in (working) and a /system reboot. Also here I see a reboot loop.
Only when I remove all two cables and input them back in, one by one it works.
Maybe you can help me… I simply do not see the problem… since 2 days! Maybe I am getting old or stupid :-/