I have little problemregarding WAP AP. I have it at gome connected on cable router serving as AP. My Windows clients work ok, but 2 Macbook Pros keep disconnecting and connecting all over again. For test I connected UniFi and connected them to it to rule out Macbooks but they work great on it. I susspect there has to be something with config since, but I cannot find anything wrong with it.
Here is my config:
Code: Select all
# feb/14/2018 09:21:44 by RouterOS 6.40.5
# software id = 1VD1-Q5H4
#
# model = RouterBOARD wAP 2nD r2
# serial number = 676605CBB2C0
/interface bridge
add fast-forward=no name=AP_Bridge
/interface ethernet
set [ find default-name=ether1 ] name=ether1-gateway
/interface wireless security-profiles
set [ find default=yes ] supplicant-identity=MikroTik
add authentication-types=wpa-psk,wpa2-psk eap-methods="" group-ciphers=\
tkip,aes-ccm management-protection=allowed mode=dynamic-keys name=\
lostinuniverse supplicant-identity="" unicast-ciphers=tkip,aes-ccm \
wpa-pre-shared-key=xxxxxxxxx wpa2-pre-shared-key=xxxxxxxx
/interface wireless
set [ find default-name=wlan1 ] band=2ghz-b/g/n channel-width=20/40mhz-eC \
disabled=no distance=indoors frequency=auto mode=ap-bridge name=\
wlan1-local security-profile=lostinuniverse ssid="xxxxxxx" \
wireless-protocol=802.11
/ip hotspot profile
set [ find default=yes ] html-directory=flash/hotspot
/ip ipsec proposal
set [ find default=yes ] enc-algorithms=aes-128-cbc
/ip pool
add name=default-dhcp ranges=192.168.88.10-192.168.88.254
/ip dhcp-server
# DHCP server can not run on slave interface!
add address-pool=default-dhcp authoritative=after-2sec-delay disabled=no \
interface=wlan1-local name=default
/system logging action
set 1 disk-file-name=log
/interface bridge port
add bridge=AP_Bridge interface=wlan1-local
add bridge=AP_Bridge interface=ether1-gateway
/ip address
add address=192.168.0.2/24 interface=AP_Bridge network=192.168.0.0
/ip dhcp-client
add comment="default configuration" dhcp-options=hostname,clientid disabled=\
no interface=ether1-gateway
/ip dhcp-server network
add address=192.168.88.0/24 comment="default configuration" gateway=\
192.168.88.1
/ip dns
set allow-remote-requests=yes
/ip dns static
add address=192.168.88.1 name=router
/ip firewall nat
# in/out-interface matcher not possible when interface (ether1-gateway) is slave - use master instead (AP_Bridge)
add action=masquerade chain=srcnat comment="default configuration" \
out-interface=ether1-gateway
/ip smb shares
set [ find default=yes ] directory=/pub
/system clock
set time-zone-name=Europe/Zagreb
/tool bandwidth-server
set authenticate=no