I'm new to Mikrotik, but so far I have managed to configure CRS to work like these:
(external router/switch) [vlanID=100, vlanID=58] <---> ether1 (CRS109) [trunk port - vlanID=100,vlanID=50]
Further on I have assigned different physical ports on CRS109 to operate in different VLANs (ex. ether2 - vlan100, ether3 - vlan58, etc)
I can not figure out hot to create an Wireless port (wlan1) to operate in vlanID=100?
Any help will be appreciated,
br
below is my working config on physical ports:
Code: Select all
/interface bridge port
add bridge=bridge comment=defconf interface=ether2
add bridge=bridge comment=defconf interface=ether3
add bridge=bridge comment=defconf interface=ether4
add bridge=bridge comment=defconf interface=ether5
add bridge=bridge comment=defconf interface=ether6
add bridge=bridge comment=defconf interface=ether7
add bridge=bridge comment=defconf interface=ether8
add bridge=bridge comment=defconf interface=sfp1
add bridge=bridge interface=ether1
/interface ethernet switch egress-vlan-tag
add tagged-ports=ether1,ether8 vlan-id=100
add tagged-ports=ether1,ether8 vlan-id=58
/interface ethernet switch ingress-vlan-translation
add customer-vid=0 new-customer-vid=100 ports=ether2
add customer-vid=0 new-customer-vid=58 ports=ether3
add customer-vid=0 new-customer-vid=58 ports=ether4
add customer-vid=0 new-customer-vid=58 ports=ether5
add customer-vid=0 new-customer-vid=58 ports=ether6
/interface ethernet switch vlan
add ports=ether1,ether2,ether8 vlan-id=100
add ports=ether1,ether3,ether4,ether5,ether6,ether8 vlan-id=58