https://wiki.mikrotik.com/wiki/Manual:S ... our_Router
I am new to mikrtik and trying to configure the hex router. The above link gives instructions but stuck at disabling of mac-server part, after executing the command I get 'expected end of command'
Am I missing something here?
Re: Securing your router
Post your command to see if there is any error.
An example to disable MAC-Server, MAC-Ping, and MAC Winbox on Ether1:
An example to disable MAC-Server, MAC-Ping, and MAC Winbox on Ether1:
Code: Select all
[admin@GissellaLojano] > tool mac-server print
Flags: X - disabled, * - default
# INTERFACE
0 X* all
1 ether1
[admin@Mikrotik] > /tool mac-server set 1 disabled=yes
[admin@Mikrotik] > /tool mac-server mac-winbox print
Flags: X - disabled, * - default
# INTERFACE
0 X* all
1 ether1
[admin@Mikrotik] > /tool mac-server mac-winbox set 1 disabled=yes
[admin@Mikrotik] > /tool mac-server ping print
enabled: yes
[admin@Mikrotik] > /tool mac-server ping set enabled=no
#*******************
#Print results
#*******************
[admin@Mikrotik] > /tool mac-server print
Flags: X - disabled, * - default
# INTERFACE
0 X* all
1 X ether1
[admin@Mikrotik] > /tool mac-server mac-winbox print
Flags: X - disabled, * - default
# INTERFACE
0 X* all
1 X ether1
[admin@Mikrotik] > /tool mac-server ping print
enabled: no
Re: Securing your router
Ok, I did the following commands from the wiki securing your router and received the following...
I tried your example for the same and below are the same results.
in both cases in the terminal window, the '[' and '1' are both red.
Code: Select all
[admin@MikroTik] > /tool mac-server set [find] disabled=yes
expected end of command (line 1 column 22)Code: Select all
[admin@MikroTik] > /tool mac-server set 1 disabled=yes
expected end of command (line 1 column 22)
Re: Securing your router
Discovery configuration syntax is changed, it uses interface lists now
https://wiki.mikrotik.com/wiki/Manual:I ... figuration
https://wiki.mikrotik.com/wiki/Manual:I ... figuration
Re: Securing your router
I'm not sure what you're saying. Can you give an example command to accomplish in securing the router?Discovery configuration syntax is changed, it uses interface lists now
https://wiki.mikrotik.com/wiki/Manual:I ... figuration
Re: Securing your router
I fixed config here too:
https://wiki.mikrotik.com/wiki/Manual:S ... _Discovery
https://wiki.mikrotik.com/wiki/Manual:S ... _Discovery
Re: Securing your router
Thanks! Those commands work now.I fixed config here too:
https://wiki.mikrotik.com/wiki/Manual:S ... _Discovery
Re: Securing your router
MikroTik caching proxy command has an extra 'set' in the command on the wiki.
Re: Securing your router
fixed