Thu Dec 13, 2018 5:53 pm
To answer my own question
Its a good idea to set up RoMON before starting.
<Solution>
SXTLTE
Configure 2 VLANs on ether 1 (vlanLTE - 100, vlanMGT - 99)
Assign vlanMGT an IP address something from the main router subnet.
Switch menu add VLAN 100 to ether1 and CPU (Not sure if CPU is necessary) and do the same for VLAN 99
Switch menu Port ether1 - VLAN Mode Secure, Leave as is, Default VLAN ID 99
Set LTE APN to Passthrough vlanLTE
Interface list add vlanLTE to WAN
IP Routes - add your Gateway here
MAIN ROUTER
Configure 2 VLANs on ether 1 (vlanLTE - 100, vlanMGT - 99)
Switch menu add VLAN 100 to ether1 and CPU (Not sure if CPU is necessary) and do the same for VLAN 99
Switch menu Port ether1 - VLAN Mode Secure, Leave as is, Default VLAN ID 99
Interface list add vlanLTE to WAN
Add vlanMGT to Bridge
This works for me I can reach SXTLTE from the IP address. any suggestions for improvements are welcome.