Community discussions

MikroTik App
 
azlan
just joined
Topic Author
Posts: 4
Joined: Wed Sep 26, 2018 7:18 am

Basic Routing

Fri Sep 28, 2018 12:42 am

Hi All,

This is what I've setup:

Code: Select all

PC1[10.10.10.1/30] ------[10.10.10.2/30----192.168.0.1/30]---------[192.168.0.2/30]PC2
PC1 : g/w 10.10.10.2
PC2: g/w 192.168.0.1

Print from CLI
# DST-ADDRESS PREF-SRC GATEWAY DISTANCE
0 ADC 10.10.10.0/30 10.10.10.1 ether8 0
1 ADC 192.168.0.0/30 192.168.0.2 ether1 0

# ADDRESS NETWORK INTERFACE
0 192.168.0.2/30 192.168.0.0 ether1
1 10.10.10.1/30 10.10.10.0 ether8

I still can't ping end to end. Any help is appreciated.
 
irico
newbie
Posts: 47
Joined: Thu Nov 10, 2016 5:35 pm

Re: Basic Routing

Fri Sep 28, 2018 11:12 am

The configuration seems correct. Possibly it's a firewall problem: on PC1, on PC2 or on the router.
 
stoser
Member Candidate
Member Candidate
Posts: 118
Joined: Sun Aug 21, 2016 12:04 am

Re: Basic Routing

Fri Sep 28, 2018 3:03 pm

based on your picture, I assume that [10.10.10.2/30----192.168.0.1/30] are two ports on the same router, specifically ether8 and ether1

Two potential problems:
1)
# ADDRESS NETWORK INTERFACE
0 192.168.0.2/30 192.168.0.0 ether1
1 10.10.10.1/30 10.10.10.0 ether8

Why are you putting the addresses of the PCs on your router? You should put 10.10.10.2 and 192.168.0.1

2) Did you set up a SRCNAT (masq) between ether 1 and ether 8?

Who is online

Users browsing this forum: BartoszP, Bing [Bot] and 52 guests