Hi.
I'm planning to make a bridge with 1 pair of wAP 60G.
Like this:
ISP (DHCP) ---(Wired)--- wAP 60G ---(Wireless)--- wAP 60G ---(Wired)--- Switch (or something)
But I stuck from very beginning. There is no way to configure wireless interface!
I can just assign IP address and gateway for bridge interface via DHCP.
[admin@MikroTik] /interface> print
Flags: D - dynamic, X - disabled, R - running, S - slave
# NAME TYPE ACTUAL-MTU L2MTU MAX-L2MTU MAC-ADDRESS
0 RS ether1 ether 1500 1598 9214 CC:2D:E0:BE:62:04
1 R ;;; defconf
bridge bridge 1500 1598 CC:2D:E0:BE:62:04
2 wlan60-1 wlan60- 1500 1600 7886 24:18:1D:22:A3:5C
[admin@MikroTik] /interface w60g> /interface w60g monitor 0
connected: no
I think that "connected: no" is problem. Any idea?