Hi,
I have put this to support@microtik.com, the automated reply said I should try the forum first so...
I purchased a RB4011iGS+5HacQ2HnD-IN. The instruction pamphlet under 'setup' says: From your PC or smartphone, connect to the wireless network name which starts with "MicroTik"
However, after power on of router that 'MicroTik' wireless network is not found by either my phone, a galaxy note 8, nor by my laptop.
I tried the reset as per this instruction: 'Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS configuration (total 5 seconds).' but it made no difference.
So I got my supplier to take this one back and give me another - however it behaves exactly the same!
I can not get access to configure this router.
I tried to use a wired connection (to port 2 I think) setting my laptop to an address on same network as would have been used via the wireless (192.168.88.0/24) but that did not work either.
Does anyone know what the trick is to get to configure these wireless RB4011's?
Regards,
Bryce S.