Community discussions

 
tesme33
newbie
Topic Author
Posts: 38
Joined: Mon May 26, 2014 10:25 pm

missing config in WinBox

Sun Feb 10, 2019 11:16 am

Hi
in the past it was possible to configure Ethernet interface to at least some distinct speed values via the winbox/webgui.
This resulted in a bandwidth setting for the interface , not using the queue.
sample see here:
[admin@router01] /interface ethernet> print detail       
Flags: X - disabled, R - running, S - slave 
 0 R  name="ether1" default-name="ether1" .......
      advertise=10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full full-duplex=yes tx-flow-control=off 
      rx-flow-control=off speed=100Mbps 
      ...
      bandwidth=10M/10M
      ...
      switch=switch1
Now the possibility is no longer in the GUI. Is this a fault or by intention ?

Who is online

Users browsing this forum: No registered users and 20 guests