Community discussions

just joined
Topic Author
Posts: 5
Joined: Sun Aug 04, 2019 7:01 am

How to find link speed on each port?

Sun Aug 04, 2019 7:08 am

Hi there!

I just got a
CRS305-1G-4S+in Switch 1x Gigabit Ethernet Port and 4X SFP+ 10Gbps Ports

Its awesome so far. I got it into SwOS mode as it will be behind a firewall performing the most basic of switch duties, no L3 or VLAN. Wondering though.. I am in Webfig and Ive looked around and cannot for the life of me been able to find a simple table where it shows me the negotiated speed of each port - the single RJ45 gigabit or the SFP+ ports. Can anybody direct me?

Also, I hear that multicast DNS maybe is in default in off and Id like it to be on. Know how to do that?

many thanks!
Posts: 38
Joined: Mon Jul 29, 2019 10:59 pm

Re: How to find link speed on each port?

Sun Aug 04, 2019 7:34 pm

Uh, admittedly I didn't run SwOS but looking at the documentation, the "Link" tab of the webinterface should do it for you?
If Auto Negotiation is on, Speed/Duplex columns are read-only and show what's negotiated.
If Auto Negotiation is of, Speed/Duplex columns are editable and port will be forced to the settings you enter.

Who is online

Users browsing this forum: No registered users and 29 guests