Trying to swap current ISP to another ISP on ether1
Posted: Fri Aug 30, 2019 8:34 am
Hi guys, I've been trying to swap the isp(isp1) to another isp(isp2) on my current config but it seems like doesnt work at all, I might be doing something really wrong. I am using rb1100ahx4
Here is my current setup. I setup my current isp(isp1) using quick set with vlan621 to works with the modem the isp provide.
Basic firewall rules, hairpin nat to access dns from local, some port forwarding. Created a lan bridge from port 2-13.
My original plan was try to make my current setup to dual wan use isp1 as backup incase isp2 is down.
But tbh my mikrotik knowledge is very limited, So I guess I should start with swapping isp first to understand more about the system.
isp1 requirement is vlan621 and running at copper which is 30mbps.
isp2 require no vlan and running at fibre for 500mbps.
Are they anyway to keep my current port and dhcp setting while swapping isp setting?
I already tried disabling vlan621 for ether1 and disabled the isp1 pppoe client interface.
What did I missing?
Here is my current setup. I setup my current isp(isp1) using quick set with vlan621 to works with the modem the isp provide.
Basic firewall rules, hairpin nat to access dns from local, some port forwarding. Created a lan bridge from port 2-13.
My original plan was try to make my current setup to dual wan use isp1 as backup incase isp2 is down.
But tbh my mikrotik knowledge is very limited, So I guess I should start with swapping isp first to understand more about the system.
isp1 requirement is vlan621 and running at copper which is 30mbps.
isp2 require no vlan and running at fibre for 500mbps.
Are they anyway to keep my current port and dhcp setting while swapping isp setting?
I already tried disabling vlan621 for ether1 and disabled the isp1 pppoe client interface.
What did I missing?