Page 1 of 1

Groove WiFi extend + LAN bridge help.

Posted: Sat Jun 20, 2020 10:39 pm
by qwert
Hey Everyone,

I’ve been working on this for the past week and I’m not sure if I’m doing something wrong, limited by hardware, or just overthinking the entire thing.

I have a Groove in a workshop that i’d like to bridge the LAN connection on a dumb switch and if possible extend the wireless range. I was able to connect the groove and extend the wireless of my existing AP, but once I connect the groove LAN to the dumb switch, I’m unable to see the dumb switch devices on the network. The devices in the workshop match my current AP range 192.168.1.x, I’ve adjusting bridge settings on the LAN as well as LAN of the Ethernet to match but it once I save these setting the groove locks up and I’m unable to access the groove unless I factory default it.

Any advice is appreciated