i hope someone can help me.
I have a CRS312-4C+8XG-RM Switch for 2 days and i had some Problems.
The Switch has the default Settings as Bridge but the Performance Is not very Good.
This Is the main Problem.
The Speeds Is like 5gigabit.
I have tried to set the mtu to 9000 (Jumbo Frames) on the Interfaces but this did not help.
The Switch is for the Connection of my nas to my Other 10 gbe devices
I have one cable direct attached with icsci to my Server and there i had 10 gb Full but the Connection from the Switch is under the half
I think it Is the Bridge function which makes it slow.
I read in a Other Thread i should change to the SWOS
Correct me if i‘m wrong.
The bridge Function makes to much overhead
to be so fast as the Switch.
So i Look How to change the Router to Switch os but i had not the opinion under System -> Routerboard > Settings
Then i try the command:
/system routerboard settings set boot-os=swos
The system recognize the Command but nothing happend
I Boots to the Router os like before.
the product Page says i can Use a Router os or a Switch os
On the end of this SWOS wiki are some serial commands
Should i buy a usb to serial cable to change the Router os to SWOS ?
Did anyone have a idea ?