44 times, I was hoping that I could maybe use the "find" command or some other magic to list a range of interfaces. Ideally I'd like to just apply this to interfaces 1-44, but I have added interfaces 45 and 46 to a different bridge (BR2), so if I could, for example, find all ports NOT in BR2, that would work pretty well, then I could always remove ports 47 and 48 later on.
Code: Select all
add bridge=BR1 interface=ether1 pvid=10 hw=yes
I tried searching the topic but didn't really see anything, unless maybe I'm missing a keyword somewhere. I'd appreciate a tip!