in a project i have 3 (L2 switches Planet GS-4210-8P2S), I have configured VLANs on each as per the requirements.
Here we need some PCs in the project to have access to some other VLANs.
so how can I do this configuration inside Mikrotik RB951Ui-2HnD
-----------
VLAN information on Switches
I have:
VLAN101
VLAN102
VLAN1
--SW1:
Port Mode Administrative VLANs
GE1 Access 101UP
GE2 Access 102UP
GE3 Access 1UP
GE4 Trunk 101T, 102T, 103T
GE5 Trunk 101T, 102T, 103T | Connected to Mikrotik Ether4 and set up the same VLANs on Mikrotik
GE6 Trunk 1UP, 101T, 102T, 103T
GE7 Trunk 1UP, 101T, 102T, 103T
GE8 Trunk 1UP, 101T, 102T, 103T
--SW2
PortModeAdministrative VLANs
GE1 Access 101UP
GE2 Access 101UP
GE3 Access 102UP
GE4 Access 102UP
GE5 Access 1UP
GE6 Access 1UP
GE7 Trunk 1UP, 101T, 102T, 103T
GE8 Trunk 1UP, 101T, 102T, 103T
--SW3
PortModeAdministrative VLANs
GE1 Access 101UP VLAN 101
GE2 Access 101UP VLAN 101
GE3 Access 102UP VLAN 102
GE4 Access 102UP VLAN 102
GE5 Access 1UP VLAN 1
GE6 Access 1UP VLAN 1
GE7 Trunk 1UP, 101T, 102T, 103T
GE8 Trunk 1UP, 101T, 102T, 103T
GE5 Trunk 101T, 102T, 103T | Connected to Mikrotik Ether4 and set up the same VLANs on Mikrotik.
What I need is if I connect a PC on SW3 port GE2 which is on VLAN 101 Untagged Port i would like to communicate with the devices on VLAN102 as well or any other wanted VLANs.
So how can I do this
I am using Winbox, and not familiar with coding.
Thanks For your Help